The router I am trying to connect to the bridged SBG6580 is an Asus RT-AC87U with the most recent AsusWRT Merlin build. I am wondering if I am missing something or my SBG6580 is a lemon and won't function as intended in bridge mode.
It sounds like setting the SBG to bridge mode should be pretty straight forward from all the different posts I have read about it (most of which had the same instructions). I contacted Comcast about it today and they said they couldn't log in because it is a customer owned router. I have tried about 10 different times with slight tweaks, but get the same result every time. When I connect my router to the modem, it says there is a problem with the DHCP from the ISP, but I can't log into the modem to check what the problem is. I followed the instructions above by and after I hit Apply, I cannot log into the SBG6580 using 192.168.100.1. I am having trouble getting my SBG6580 to work properly in bridge mode. That needed to be power cycled, otherwise it would still warn about Double NAT. But when I tried that the router would just reset its configuration back. It actually suggests the opposite, changing Gateway Mode to Bridged. Plug the coaxial cable back into the modem and power cycle it.Īfterwards you can reach the router configuration page at:.Basic > Setup > Primary Network Only Mode -> Bridged.Connect to and login with “admin” / “motorola”.When modem is back on plug in a computer with an Ethernet cable into the modem.The modem will be auto-reconfigured once you plug in the coax cable. This resets all settings to factory defaults.
Motorola sbg6580 passthrough mac address how to#
They tell me that I must not know how to open ports in Port Forwarding. Most of the Techs have no idea to what I am referring. How would I prove who is at fault here? Any ideas? I have been on the phone with Xfinity for hours. " Some of the old standards are visible like 8080, but none of the other Ports that I have tried to open are visible. However, no one can "see" my opened ports. Ports 4001 through 4016 are opened in Port Forwarding in my router. For example, I have opened ports for my Moxa 16-Port RS-232 Server.
Motorola sbg6580 passthrough mac address software#
Ever since Xfinity "worked" in my neighborhood, ports that I open through my router via Port Forwarding can not be found via or via any software that I am using remotely to access my various ports. They seem to have gotten internet speed back up and internet connections are not dropping every few minutes as they were for many weeks.
Xfinity was working in my neighborhood for weeks. I think that the problem is my ISP at my local cable hub.not at my home location/router & LAN.We had a lot of trouble in my neighborhood recently. Actually, I don't think that the problem is in the router. I have a question about this "great" little router. RE: Motorola SBG6580.Port Forwarding Problem.Hi everyone.